Mesh separation and cutting center MAB6

Process description

Stack is transported in with a roller conveyour
the Shear elevator lifts up the stack until the upper Mesh is in Pick up position
Mesh seperator moves to pick up position an picks up the upper mesh (linewire or crosswire)
Roller curtain moves to feed position – meanwhile the pick up and the feed unit are moving to start position
Mesh is aligned at a fixes block
Mesh is gripped in the rear position and is feeded in the shear to the exact length of the mesh strip
The shear cuts and the mesh strip falls on a conveyor belt. As it is needed, the stripes are stacked turned over or not, as required
Feeding in the mesh to next cutting position
Repetition Step 6/7
Last stripe is pushed through the shear with a pneumatic cylinder